Changing the Filters in Your HUM Water Saver 75 Reverse Osmosis System is super easy, check this out! Shop HUM Water Saver 75
https://waterestore.ca/products/hum-w... Shop HUM Water Saver 75 Replacement Filters here
https://waterestore.ca/products/water... 1. Turn off incoming water supply and valve on the storage tank. Place a tray under the system to catch any water that spills during removal of the filter housings. 2. Open faucet to release pressure. 3. Unscrew bottom of filter housings from caps. Use the filter wrench. Discard used cartridges. I like to do this one at a time to minimize the chance of mixing up the filters. 4. Remove black rubber O-rings from grooves in housings. Wipe grooves and O-rings clean; set O-rings aside. 5. Wash out housings and rinse thoroughly. 6. Lubricate each O-ring with a coating of clean silicone grease. With two fingers, press each O-ring securely into groove below the threads of the appropriate housing. CAUTION: The rubber O-ring provides the water-tight seal between the cap and the bottom of the housing. It is important that the O-ring be properly seated in the groove below the threads of the housing or a water leak could occur. 7. Insert cartridges in the bottom of the housings. Make sure cartridge slips over standpipe in the bottom of the housing. 8. Screw bottoms of housings back onto caps securely; do not over-tighten. 4th Stage Post-Filter Cartridge: post-filter should be replaced every twelve months. 1. Remove filter from bracket and remove tubes from fittings by pressing in collar around the fitting while pulling the tubing out with your other hand. 2. Check out this video about using quick connect fittings
• How to use Quick ... 3. NOTE: If quick connect fittings need to be installed, tape threads of fittings with 3 wraps of plumber tape and attach to filter. NOTE: The filter has an arrow on it showing the direction of flow. The tee fitting connects to the inlet side of the filter and the elbow fitting attaches to the outlet side. NOTE: Hand tighten fittings, then tighten with wrench 1/4 turn. 4. Attach 4th stage filter to bracket with the tee fitting on the right hand side. 5. Attach tubes to fittings by pushing in until the tube stops. Check to see if tube is in place by trying to gently pull tube out Turn on cold water supply. Check for leaks. Continue to check periodically to make sure no leaks develop. Click here for your next video on Reverse Osmosis water filtration and I’ll see you there!
• Ultraviolet or UV... Any questions or comments about this video? Please enter them below, I read them all and would love to answer yours. LOVE GARY THE WATER GUY AND WANT TO LEARN MORE ABOUT WATER FILTRATION FOR YOUR FAMILY? HERE ARE SOME NEXT STEPS! Sign up to keep in touch with Gary!
https://mailchi.mp/waterestore.com/su... 2) LET’S CONNECT!
https://www.facebook.com/WaterEstore/https://twitter.com/WaterEstorehttps://www.linkedin.com/company/the-...https://www.instagram.com/Water_Estore/https://www.instagram.com/WaterStoreM... 3) CONTACT! info@WaterEstore.com or info@WaterStoreMidland.com 4) SHOP! Midland
https://www.WaterEstore.com Please share this video
• EASY HUM Water Sa...